The EnduraFlood Univeral Mounting Trim MUNI-TRIM is a mounting and finishing trim for the vertical separation between 1/2" sheetrock above, and DENDU-BOAR panels below, as well as for the horizontal separation between ENDU-BOARD panels.
EnduraFlood MUNI-TRIM can also be used with common 0.42" cement boards. MUNI-TRIM provides a decorative, modern and clean brushed Aluminum finish.
- Perfect for creating a transition from 1/2" sheetrock to ENDU-BOARD panels
- Can also be used with common 0.42" cement board
- Allows for easy removal and re-use of the installed panels for inspection, or to allow the wall behind to dry out.
- Used with 1/2" drywall thickness above.
- Material: Brushed Aluminum
- Matching trim pieces for inside and outside corners are available separately
- Use together with MERTI-COR/O for outside corners, and with MERTI-COR/I for inside corners
EnduraFlood MUNI-TRIM, 95" long
EnduraFlood MUNI-TRIM is mounted to stapled to wooden studs with MUNI-NAIL, and to metal studs with UNI-RIV.
Clamp MUNI-TRIM onto the studs using a small, non-marring set of clamps. Use a 3/32" drill to drill pilot holds through MUNI-TRIM at each stud location.
Mounting to metal studs:
- be sure to drill through the metal stud
- Insert UNI-RIV and use a Rivet Tool to tighten the UNI-RIV
Mounting to wooden studs:
- after drilling through MUNI-TRIM, avoid drilling into the wooden stud
- insert MUNI-NAIL through the pilot hole in MUNI-TRIM, and slightly tap the nail into place
- use a Trim Nail Punch to hammer the nail firmly into place
Once mounted, MUNI-TRIM allows ENDU-BOARD panels to be snapped into place from underneath. Common 0.42" cement boards can also be used. The ENDU-BOARD or cement board panels can be removed and reused if needed in the future.