Any tips for measuring & making holes into the ENDU-BOARD for outlets or wires of baseboard heaters? I didn't see this in the tips videos (and am located in Montreal, Canada, so I'm not sure if there are any affiliated contractors in the area, so am planning to do they install myself).
top of page
bottom of page
Cutting in the outlet holes is pretty easy with a utility knife. To get the right location, we do the same as we do with sheetrock. Add a but of chalk to the box and press your board against it so that it would be in position. You then have the outline of the box in the back and you just follow that with the knife. Maybe add 1/8 to 1/4 inch for some extra room. Since the boards are white use some colored chalk from a chalk line or so.