At a few places in our basement, we have two immediately adjacent corners (almost like a "Z"), of an inside then then outside corner, with only a couple inches along a short wall. Or around the edges of our closets (sliding doors) where it would be two outer corners right next to each other. What would be the best way to manage this? Buying all the appropriately HORI-CORs, and cutting them short to fit? Other ideas? Many thanks!
top of page
bottom of page
If you have two corners next to each other very close to each other, you can do one of two things. You can use a HoriCor I or O and mitercut a 45 angle for the second corner into one of its legs. The legs are always 6 inches long. You can also take a longer piece of your UniTrim and fabricate your own double-corner piece. It depends on your level of experience with the system. We have found that every situation is a bit different, but that you can adjust the system to pretty much anything that you come across. Hope this helps! Greetings
can you upload photos of a sketch?
brett